PN532 NFC RFID Read / Write Module V3 Kit

Description

Support NFC RFID reading and writing, P2P communication with peers

Support I2C, SPI and HSU (High UART), easy to change among these modes

On-board level shifter, standard 5V TTL for I2C and UART, 3.3V TTL SPI

RFID reader/writer supports: 1k, 4k, Ultralight, and DesFire cards, ISO/IEC 14443-4 cards such as CD97BX, CD light, Desfire, P5CN072 (SMX), Innovision Jewel cards such as IRT5001 card, FeliCa cards such as RCS_860 and RCS_854

Introduction

NFC is a popular technology in recent years.Almost all the high-end phone in the market support NFC.

Near field communication (NFC) is a set of standards for smart phones and similar devices to establish radio communication with each other by touching them together or bringing them into close proximity, usually no more than a few centimeters.

For electronics geeks, we also want to use NFC technology to make our own things. So we build this NFC RFID module. This module is built around PN532.PN532 is very popular in NFC area.

We almost break out all the IO pins of NXP532 on this module. Users could easily connect and play. With our Arduino Sensor Shield,it is very easy to plug and play. However, if users want to use other interface such as UART or SPI, this module also makes it easy to connect those pins.

Feature:
1. Small dimension and easy to embed into your project
2. Support I2C, SPI and HSU (High Speed UART), easy to change between those modes
3. Support RFID reading and writing, P2P communication with peers, NFC with Android phone
4. RFID reader/writer supports: * Mifare 1k, 4k, Ultralight, and DesFire cards
●ISO/IEC 14443-4 cards such as CD97BX, CD light, Desfire, P5CN072 (SMX)
●Innovision Jewel cards such as IRT5001 card
●FeliCa cards such as RCS_860 and RCS_854
5. Up to 5cm~7cm reading distance
6. On-board level shifter, Standard 5V TTL for I2C and UART, 3.3V TTL SPI
7. Arduino compatible, plug in and play with our shield

Package Include:

1x PN532 NFC RFID Read  Write Module V3 Kit